po300code blues (Part II)

[ultraflip]

bringing this thread back from the grave...

can anyone list the causes for a p0300 code?

thanks...
flip

[Blaze]

That causes can be somewhat debatible.
A sticky would have been good 2 years ago.
I don't know if it's necessary now.

Officially it was caused by an over sensitive cam position sensor.

What contributes to setting it off could be any number of things.

* Get the Mitsu Reflash before checking any of these.
1. 1 bad or mis-gapped plug.
2. (for me) Running a VTA BOV set my off
3. (Alvin) Dead/low compression in a piston
4.
5.



bringing this thread back from the grave...

can anyone list the causes for a p0300 code?

thanks...
flip

[ultraflip]

thanks for the quick response blaze...

reasoning for me asking is that my car seems to be throwing this code now... i changed the plugs... i have an 04... so my car is not elidgable for the reflash i think... and my BOV is recirced... i'm at a loss right now

split this and make a new thread for me... ;)

flex your mod powers.. =P

[Macky]

get the IX then flipster.

[Blaze]

Alvin's problem was a dead piston.
(though I doubt you want to hear THAT)



thanks for the quick response blaze...

reasoning for me asking is that my car seems to be throwing this code now... i changed the plugs... i have an 04... so my car is not elidgable for the reflash i think... and my BOV is recirced... i'm at a loss right now

split this and make a new thread for me... ;)

flex your mod powers.. =P